Mitsubishi Outlander: Operation sound setting
You can turn off the operation sounds of the multiinformation meter switch and daytime dipper button.
1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select
(operation sound setting).
3. Press and hold the multi-information meter switch for about 2 seconds or more to switch in sequence from ON (operation sound on) → OFF (operation sound off) → ON (operation sound on).
The setting is changed to the selected condition.
Note
► The memory of the operation sound setting is erased if the battery is disconnected,
and it returns automatically to ON (operation sound on).
► The operation sound setting only deactivates the operation sound of the multi-information
meter switch and daytime dipper button. The warning display and other sounds cannot
be deactivated.
READ NEXT:
Changing the time until “REST REMINDER” is displayed
The time until the display appears can be changed.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer
Changing the turn-signal sound
It is possible to change the turn-signal sound.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to
Changing the momentary fuel consumption display (Type 2)
It is possible to change the bar graph setting of the momentary fuel consumption
display.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setti
SEE MORE:
To check the fluid level
The fluid level must be between the “MAX” and “MIN” marks on the reservoir.
The fluid level is monitored by a float. When the brake fluid level falls below
the “MIN” mark, the brake fluid warning lamp lights up.
The fluid level falls slightly with wear of the brake pads, but this d
Reversing sensor system operation indication lamp
In case there is a malfunction in the reversing sensor system, the reversing
sensor system operation indication lamp will blink and the warning buzzer will sound
for approximately 5 seconds. Even after the buzzer has stopped sounding, the indication
lamp will continue flashing until the system
