Mitsubishi Outlander: Changing the language cooperative control
The language used in MITSUBISHI Multi-Communication System (MMCS) (if so equipped) or the Bluetooth® 2.0 interface (if so equipped) can be changed automatically to the same language as that shown in the multi-information display.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select
(language cooperative control).
3. Press and hold the multi-information meter switch to switch in sequence from A or 1 (language cooperation enabled) → M, 2 or P (language cooperation disabled) → A or 1 (language cooperation enabled).
The setting is changed to the selected condition.
Note
► The memory of the language cooperative control is erased if the battery is
disconnected, and it returns automatically to A or 1 (language cooperation enabled).
► The language display modified with the language setting can be switched in the
following manner.
• When A or 1 (language cooperation enabled) has been selected with the language
cooperative control, the language for MITSUBISHI Multi-Communication System (MMCS)
(if so equipped) or the Bluetooth® 2.0 interface (if so equipped) is automatically
changed to the language selected for the multi-information display.
• When M, 2 or P (language cooperation disabled) has been selected with the language
cooperative control, the language for MITSUBISHI Multi-Communication System (MMCS)
(if so equipped) or the Bluetooth® 2.0 interface (if so equipped) is not automatically
changed to the language selected for the multi-information display.
READ NEXT:
Operation sound setting
You can turn off the operation sounds of the multiinformation meter switch and
daytime dipper button.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch fr
Changing the time until “REST REMINDER” is displayed
The time until the display appears can be changed.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer
Changing the turn-signal sound
It is possible to change the turn-signal sound.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to
SEE MORE:
3–point type seat belt (with emergency locking mechanism)
This type of belt requires no length adjustment. Once worn, the belt adjusts
itself to the movement of the wearer, but in the event of a sudden or strong shock,
the belt automatically locks to restrain the wearer’s body.
To fasten
Pull the seat belt out slowly while holding the latch plate
Replacement of lamp bulbs
Before replacing a bulb, ensure the lamp is off. Do not touch the glass part
of the new bulb with your bare fingers; the skin oil left on the glass will evaporate
when the bulb gets hot and the vapour will condense on the reflector and dim the
surface.
CAUTION:
● Bulbs are extremely ho
