Mitsubishi Outlander manuals

Mitsubishi Outlander: Changing the temperature unit

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Changing the function settings (when the ignition switch is “ON”) / Changing the temperature unit

The display unit for temperature can be switched.

1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen. Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select (temperature unit setting).

3. Press and hold the multi-information meter switch for about 2 seconds or more

3. Press and hold the multi-information meter switch for about 2 seconds or more to switch in sequence from °C → °F → °C.

The setting is changed to the selected temperature unit.

► If the battery is disconnected, the unit setting is erased from memory and Note

► If the battery is disconnected, the unit setting is erased from memory and is automatically set to °C.

READ NEXT:

 Changing the display language

The language of the multi-information display can be switched. 1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu sc

 Changing the language cooperative control

The language used in MITSUBISHI Multi-Communication System (MMCS) (if so equipped) or the Bluetooth® 2.0 interface (if so equipped) can be changed automatically to the same language as that shown

 Operation sound setting

You can turn off the operation sounds of the multiinformation meter switch and daytime dipper button. 1. Press and hold the multi-information meter switch for about 2 seconds or more to switch fr

SEE MORE:

 Starting the engine (petrol-powered vehicles)

The starting procedure is as follows: 1. Fasten the seat belt. 2. Make sure the parking brake is applied. 3. Depress and hold the brake pedal. 4. Fully depress the clutch pedal. (M/T) Note ► On vehicles with the Auto Stop & Go (AS&G) system, the starter will not operate unless

 Control panel

A- Temperature control dial B- Air selection switch C- Blower speed selection dial D- Air conditioning switch E- Mode selection dial F- Rear window demister switch NOTE • On vehicles with the heater, button (D) is not available for use. The indicator below the button doesn’t come on

© 2010-2025 Copyright www.mioutlander.com