Mitsubishi Outlander: Cigarette lighter
The cigarette lighter can be used while the ignition switch is in the “ON” or “ACC” position.
1- Push all the way in.
The cigarette lighter will automatically return to its original position with a “click” when ready. Pull it out for use.
After use, insert the cigarette lighter to its original position in the socket.
Note
► Do not leave the cigarette lighter removed from its socket, because the socket might become clogged by foreign material and be short-circuited.
Caution
► Do not touch the heating element or the cigarette lighter housing, hold
the knob only to prevent burns.
► Do not allow children to operate or play with the cigarette lighter as burns may
occur.
► Something is wrong with the cigarette lighter if it does not pop back out within
approximately 30 seconds of being pushed in.
Pull it out and have the problem corrected at MITSUBISHI MOTORS Authorized Service
Point.
► When the cigarette lighter socket is used as a power source for an electric appliance,
be sure that the electric appliance operates at 12 V and has an electric capacity
of 120 W or less. In addition, long use of the electric appliance without running
the engine may run down the battery.
► When using the cigarette lighter and the accessory socket simultaneously, make
sure the total power consumption of these does not exceed 120 W at 12 V.
READ NEXT:
Accessory socket
The accessory socket can be used while the ignition switch is in the “ON” or
“ACC” position.
Caution
► Be aware that using electronic equipment with the engine off may run the
bat
Interior lamps
1- Cargo room lamp
2- Rear room lamp
3- Front room & map lamps
Note
► If you leave the interior lamps on without running the engine, you will run
down the battery.
Before you leave
Front room & map lamps
1 (DOOR) - The lamp illuminates when a door or the rear hatch is opened. It goes
off about 15 seconds after the door or rear hatch is closed. However, the lamp goes
off immediately in the follow
SEE MORE:
Windscreen washer
The windscreen washer can be operated with the ignition switch or the operation
mode in ON or ACC.
The washer fluid will be sprayed onto the windscreen by pulling the lever towards
you.
When the wipers are not in operation or in intermittent operation, by pulling
the lever towards you, the w
Hill start assist (vehicles with Twin Clutch SST)
The hill start assist makes it easy to start off on a steep uphill slope by preventing
the vehicle from moving backwards. It keeps the braking force for about 2 seconds
when you move your foot from the brake pedal to the accelerator pedal.
Caution
► Do not overly rely on the hill start
