Mitsubishi Outlander: Demisting of the windscreen and door windows
CAUTION
For safety, make sure you have a clear view through all windows.
To remove frost or mist from the windscreen and door windows, use the mode selection
dial (“
” or “
”).
- To keep the windscreen and door
windows clear of mist, and to keep leg area heating (when driving in rain or snow).
1- Set the air selection switch (A) to the outside position.
2- Set the mode
selection dial to the “” position.
3- Select the desired blower speed by turning the blower speed selection dial.
4- Select the desired temperature by turning the temperature control dial.
5-
Push the air conditioning switch (B). (vehicles with air conditioning)
- For quick demisting
1- Set the air selection switch (A) to the outside position.
2- Set the mode
selection dial to the “
” position.
3- Set the blower speed to the maximum speed position.
4- Set the temperature
to the maximum temperature position.
5- Push the air conditioning switch (B).
(vehicles with air conditioning)
NOTE
(1) To demist effectively, direct the air flow from the side ventilators towards
the door windows.
(2) Do not set the temperature control dial around the max.
cool position. Cool air will blow against the window glasses and form mist on them.
READ NEXT:
Introduction of outside air
To introduce air into the vehicle during hot weather, set the air selection switch
(A) to the outside position and set the temperature control dial to the position
shown in the illustration. Be
Cooling (Vehicles with air conditioning)
Set the mode selection dial to the “”
position.
Set the air selection switch (A) to the outside position and push the air conditioning
switch (B).
Adjust the temperature by turning the tem
Automatic air conditioning*
The air conditioning can only be operated while the engine is running.
CAUTION
When using the air conditioning, the idling speed may slightly increase
as the air conditioning compressor is switche
SEE MORE:
Stop and tail lamps and rear turn-signal lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a
cloth or other object at the edge of the cover and pry gently to remove the cover.
2. Remove the socket and bulb assemblies by turning them anticlockwise.
A- Rear turn-signal lamp
B- Stop and tail lamp
3. Remove
When turning from “ACC” to “LOCK”
[Vehicles equipped with M/T] Put the gearshift lever into the “N” (Neutral) position,
and slowly turn the ignition switch to the “LOCK” position while pressing it.
[Vehicles equipped with CVT or Twin Clutch SST] First, set the selector lever
(CVT) or the gearshift lever (Twin Clutch SST
