Mitsubishi Outlander: When turning from “ACC” to “LOCK”
[Vehicles equipped with M/T] Put the gearshift lever into the “N” (Neutral) position, and slowly turn the ignition switch to the “LOCK” position while pressing it.
[Vehicles equipped with CVT or Twin Clutch SST] First, set the selector lever (CVT) or the gearshift lever (Twin Clutch SST) to the “P” (PARK) position, and then slowly turn the ignition switch to the “LOCK” position while pressing it.
Note
► Vehicles equipped with CVT or Twin Clutch SST, the ignition switch cannot be turned to the “LOCK” position unless the selector lever (CVT) or the gearshift lever (Twin Clutch SST) is in the “P” (PARK) position.
Caution
► Do not turn the ignition switch to the “LOCK” position while driving. The
steering wheel will be locked, causing loss of control.
► If the engine is stopped while driving, the brake servomechanism will cease to
function and braking efficiency will deteriorate.
Also, the power steering system will not function and it will require greater manual
effort to operate the steering.
► Do not leave the ignition switch in the “ON” or “ACC” position for a long time
when the engine is not running, doing so will cause the battery to be discharged.
► Do not turn the ignition switch to the “START” position when the engine is running,
doing so could damage the starter motor.
READ NEXT:
Warning activation
In order to prevent vehicle theft or the accidental operation of the keyless
operation system, the buzzer and the display on the information screen in the multi-
information display are used to al
Keyless operation key take-out monitoring system
Type 1
Type 2
When the vehicle is parked with the ignition switch in any position other than
“LOCK” (PUSH OFF), if you close the door after opening any of the doors and taking
the keyles
Key lock-in prevention system
When the ignition switch is in the “LOCK” (PUSH OFF) position, if you close all
the doors and the rear hatch with the keyless operation key left in the vehicle
and you try to lock the doors
SEE MORE:
Customizing the air selection (Changing function settings)
Functions can be changed as desired, as stated below.
► Enable automatic air control:
When the heater operates, the air selection switch will be automatically controlled.
► Disable automatic air control:
Even when the heater operates, the air selection switch will not be automaticall
To operate
To operate the system, move the gearshift lever or selector lever to the “R”
position while the ignition switch is in the “ON” position. When the reversing sensor
system is operated, the reversing sensor system operation indication lamp (A) will
turn on. To stop the operation, push the
