Mitsubishi Outlander: Dipper (High/Low beam change)
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Combination headlamps and dipper switch / Dipper (High/Low beam change)
When the lamp switch is in the 
position, the beam changes from high to low (or low to high) each time the lever
is pulled fully (1). While the highbeam is on, the high-beam indication lamp in
the instrument cluster will also illuminate.
READ NEXT:
Headlamp flasher
The high-beams flash when the lever is pulled slightly (2), and will go off when
it is released.
When the high-beam is on, the high-beam indication lamp in the instrument cluster
will illuminate.
Welcome light (for vehicles equipped with the keyless entry system or the keyless
operation system)
Except for vehicles for Russia, Kazakhstan and Ukraine, this function turns on
the position and tail lamps for about 30 seconds after the UNLOCK switch (A) on
the remote control transmitter is pre
Coming home light
This function turns on the headlamps in the low beam setting for about 30 seconds
after the ignition switch is turned to the “LOCK” position.
1. Turn the combination headlamps and dipper switch
SEE MORE:
Central door locks
NOTE
• Each of the doors can be locked or unlocked independently by using the inside
lock knob.
• When locking or unlocking with the key on the driver’s door, only the driver’s
door will lock or unlock.
• Repeated continuous operation between lock and unlock could activate the cent
Cargo area cover
To use
1. Draw out the cover retracted by spring and insert it in the mounting grooves
(A).
2. Remove the cover from the mounting grooves, and the cover will be rolled back
into the retracted position.
NOTE:
● Do not put luggage on the cargo area cover.
To change
There are 2 inst
© 2010-2026 Copyright www.mioutlander.com
