Mitsubishi Outlander: Headlamp flasher
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Combination headlamps and dipper switch / Headlamp flasher
The high-beams flash when the lever is pulled slightly (2), and will go off when it is released.
When the high-beam is on, the high-beam indication lamp in the instrument cluster will illuminate.
Note
► The high-beams can also flash when the lamp switch is OFF.
► If you turn the lamps off with the headlamps set to high-beam, the headlamps are
automatically returned to their low-beam setting when the lamp switch is next turned
to the
position.
READ NEXT:
Welcome light (for vehicles equipped with the keyless entry system or the keyless
operation system)
Except for vehicles for Russia, Kazakhstan and Ukraine, this function turns on
the position and tail lamps for about 30 seconds after the UNLOCK switch (A) on
the remote control transmitter is pre
Coming home light
This function turns on the headlamps in the low beam setting for about 30 seconds
after the ignition switch is turned to the “LOCK” position.
1. Turn the combination headlamps and dipper switch
SEE MORE:
Keyless entry system
Press the remote control switch, and all doors and the rear hatch will be locked
or unlocked as desired.
It is also possible to operate the door outside rear-view mirrors.
1- LOCK switch
2- UNLOCK switch
3- Indication lamp
Installing a child restraint system to a 3-point type seat belt (with emergency
locking mechanism)
Installation:
1. Fasten the seat belt to secure the child restraint system. Make sure you hear
a “click” when you insert the latch plate in the buckle.
2. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all directions to be sure it is secure.
Warning
© 2010-2026 Copyright www.mioutlander.com
