Mitsubishi Outlander: Electronic immobilizer (Anti-theft starting system)
The electronic immobilizer has been designed to significantly reduce the possibility of vehicle theft.
The purpose of the system is to immobilize the vehicle if an invalid start is attempted. A valid start attempt can only be achieved (subject to certain conditions) using a keyless operation system “registered” to the immobilizer system.
All of the keys provided with your new vehicle have been programmed into the vehicle’s electronics.
Refer to “Keyless operation system: Ignition switch” on pages 1-11 and 1-18.
Note
► If you lose one of the keyless operation keys, contact a MITSUBISHI MOTORS Authorized Service Point as soon as possible.
To obtain a replacement or extra spare key, take your vehicle and all remaining keys to your MITSUBISHI MOTORS Authorized Service Point. All the keys have to be re-registered in the immobilizer computer unit.
The immobilizer can register up to 4 different keys.
READ NEXT:
Ignition switch
In order to prevent theft, the engine will not start unless a preregistered keyless
operation key is used.
(Engine immobilizer function)
LOCK (PUSH OFF)
The position in which the steering wheel
When turning from “LOCK” (PUSH OFF) to “ACC”
Push the ignition switch and turn it slowly.
A- Steering wheel locked
B- Steering wheel released
Note
► If the ignition switch does not turn from “LOCK” (PUSH OFF) to “ACC”, press
When turning from “ACC” to “LOCK”
[Vehicles equipped with M/T] Put the gearshift lever into the “N” (Neutral) position,
and slowly turn the ignition switch to the “LOCK” position while pressing it.
[Vehicles equipped with C
SEE MORE:
Engine coolant
To check the coolant level
A transparent coolant reserve tank (A) is located in the engine compartment.
The coolant level in this tank should be kept between the “LOW” and “FULL” marks
when measured while the engine is cold.
To add coolant
The cooling system is a closed system and no
Vehicle labeling
1-Vehicle identification number
The vehicle identification number is stamped on the bulkhead as shown in the
illustration.
2-Vehicle information code plate
The vehicle information code plate is riveted as shown in the illustration.
The plate shows model code, engine model, transmission model
