Mitsubishi Outlander: Except for vehicles equipped with Twin Clutch SST
Always stop the vehicle in a safe place before operating.
The following information is included on the multi-information display: warnings, odometer, tripmeter, service reminder, engine coolant temperature, fuel remaining, outside temperature, selector lever position, average and momentary fuel consumption, driving range, average speed and meter illumination.
It is also possible to change elements such as the language and units used on the multi-information display.
1-mark display screen (when the ignition switch is “OFF”) ®
2- Information screen (when the ignition switch is “OFF“) ®
Interrupt display screen (when the ignition switch is “OFF”) ®
3- Door ajar warning display screen (when the ignition switch is “OFF”) ®
4- ACD (Active centre differential system) control mode display screen ®
5. Outside temperature display screen ®
6- mark display screen (when the ignition switch is “ON”) ®
7- Information screen (when the ignition switch is “ON”) ®
Interrupt display screen (when the ignition switch is “ON”) ®
8. Fuel remaining display screen ®
9- Twin Clutch SST control mode display screen ®
10- Engine coolant temperature display ®
11- Gearshift lever position display screen ®
12- Active Stability Control (ASC) OFF display screen ®
13. ECO mode indicator (except for vehicles for Russia, Kazakhstan and Ukraine)
®
READ NEXT:
Instruments and controls
Note
► The fuel units, temperature units, display language, and other settings can
be changed.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
►
Multi-information meter switch
Each time the multi-information meter switch is operated, a sound is emitted
and the multi-information display changes between information such as warnings,
odometer, tripmeter, service reminder,
Mark display screen (when the ignition switch is “OFF”)
If you press the multi-information meter switch and return from the warning display
screen to the previous screen, the mark is displayed.
Refer to “To return to the screen displayed before the
SEE MORE:
ACD control mode switch
When the ignition switch is set to the “ON” position, operate the AWC switch
to change the control mode.
Each time the switch is pushed, the control mode changes in the order “TARMAC”
→ “GRAVEL” → “SNOW” → “TARMAC”.
Note
► The control mode can be
Windscreen washer
The windscreen washer can be operated with the ignition switch in the “ON” or
“ACC” position.
The washer fluid will be sprayed onto the windscreen by pulling the lever towards
you.
When the wipers are not in operation or in intermittent operation, by pulling
the lever towards you, th
