Mitsubishi Outlander: For emergencies
Mitsubishi Outlander 2007-2013 Owner's Manual / For emergencies
- If the vehicle breaks down
- Emergency starting
- Engine overheating
- Tools and jack
- How to change a tyre
- Towing
- Operation under adverse driving conditions
READ NEXT:
If the vehicle breaks down
If the vehicle breaks down on the road, move it to the shoulder and use the hazard
warning flashers.
Refer to “Hazard warning flasher switch”.
If the engine stops/fails
Vehicle operation and
Emergency starting
If the engine cannot be started because the battery is weak or dead, the battery
from another vehicle can be used with jumper cables to start the engine.
WARNING:
● To start the engine using
Engine overheating
When the engine has overheated, the information screen in the multi-information
display will be interrupted and the engine coolant temperature warning display will
appear. The screen will then cha
SEE MORE:
Front Suspension
General Information
The MacPherson strut type suspension is adopted.
CONSTRUCTION DIAGRAM
Fastener Tightening Specifications
General Specifications
COIL SPRING
NOTE: * : Heavyduty suspension for FWD
Service Specifications
Lubricant
Front Suspension Diagnosis
INTRODUCTION TO FRONT SUSPENSION DI
Balancer Chain
REMOVAL AND INSTALLATION
Removal steps
Drive plate bolt
Adapter plate
Drive plate
Rear oil seal
Balancer shaft chain tensioner
Balancer shaft tensioner lever
Balancer shaft chain guide
Balancer shaft module
Balancer chain
Crankshaft sprocket
Ladder frame
Required Special Tool:
MB9918
© 2010-2026 Copyright www.mioutlander.com
