Mitsubishi Outlander child restraint top tether strap routed over the rear seatback and attached to the tether anchor

WARNING

  • Child restraint anchors are designed to withstand only the loads applied by a correctly installed child restraint. Never use these anchors to attach adult seat belts, secure cargo or connect other equipment to the vehicle. Improper use may damage the anchor and prevent a child restraint from being secured correctly. A child could be seriously injured or killed in a collision if the restraint is attached to a damaged anchor.

The child restraint top tether strap must be used whenever a compatible child restraint is installed with the LATCH lower anchor attachments in the Mitsubishi Outlander.

Begin by securing the child restraint to the correct LATCH lower anchors and confirming that both attachments are fully engaged.

1. Remove the head restraint when necessary to provide the correct fit for the child restraint, and store it securely where it cannot move around inside the vehicle. Reinstall the head restraint after the child restraint has been removed.

2. Route the top tether strap over the seatback in the manner specified by the child restraint manufacturer. Make sure the strap is not twisted or trapped behind the restraint.

3. Attach the top tether hook securely to the designated tether anchor point shown in the illustration. Use only the anchor assigned to the seating position where the restraint is installed.

4. Complete the applicable child restraint installation procedure described in this section, then tighten the tether strap according to the restraint manufacturer's instructions until unnecessary slack has been removed.

If you have questions about routing or securing a top tether strap in the Mitsubishi Outlander, Mitsubishi Motors recommends visiting an authorized Mitsubishi Motors dealer for assistance.

    READ NEXT:

     Forward-facing child restraint installation using the seat belts

    WARNING The three-point seat belt must be placed in Automatic Locking Retractor [ALR] mode when installing a child restraint. If ALR mode is not activated, the restraint may remain loose or tip ov

     Installing top tether strap

    WARNING Child restraint anchors are designed to withstand only the forces applied by a correctly fitted child restraint. Never use these anchors to attach adult seat belts, secure cargo or con

     Booster seats

    Precautions on booster seats WARNING If a booster seat or vehicle seat belt is used incorrectly, the risk of serious injury or death to the child during sudden braking or a collision increases si

    SEE MORE:

     MI-PILOT Assist

    This section explains the operation and key functions of the following driver-assistance features available for the Mitsubishi Outlander: MI-PILOT Assist (general system operation) MI-PILOT Assist with Navi-link (additional functionality, if so equipped) WARNING Failure to follow the

     Third row seats

    The Mitsubishi Outlander third row seats provide additional passenger capacity and can be adjusted or folded when the rear seating area is not required. Before carrying passengers, make sure the seatbacks, head restraints and seat belts are correctly positioned and that each seat is securely locked.