Mitsubishi Outlander manuals

Mitsubishi Outlander: Interrupt display screen (when the ignition switch is “OFF”)

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Interrupt display screen (when the ignition switch is “OFF”)

When there is information to be announced, such as lamp reminders, the buzzer sounds and the multiinformation display switches to the warning display screen. Refer to the appropriate page and take the necessary measures.

When the cause of the warning display is eliminated, the warning display goes out automatically.

Refer to “Warning display list (when the ignition switch is “OFF”)”.

1- Information generated

1- Information generated
2- Cause eliminated

To return to the screen displayed before the warning display

Even if the cause of the warning display is not eliminated, you can return to the screen that was displayed before the warning display.

If you press the multi-information meter switch, the display screen switches to the screen that was displayed before the warning display and the mark (A) is displayed.

Note

► Warning display screens with a Note

► Warning display screens with a or  mark displayed in the upper right or of the screen can be switched. If you want to switch the display, press the multi-information mark displayed in the upper right of the screen can be switched. If you want to switch the display, press the multi-information meter switch as follows.
: Press for about 2 seconds or more.: Press lightly.
Redisplay of a warning display screen: Press for about 2 seconds or more.

Redisplay of a warning display screen

When the mark lightly press the multi-information meter switch a few times, the warning display is displayed, if you lightly press the multi-information meter switch a few times, the warning display screen you switched from is displayed again. Refer to “Information screen (when the ignition switch is “OFF“)”.

READ NEXT:

 Door ajar warning display screen (when the ignition switch is “OFF”)

If any of the doors or the rear hatch is not completely closed, this displays the open door or rear hatch. 1- Doors and rear hatch are closed 2- Doors or rear hatch is open

 Information screen (when the ignition switch is turned from “OFF” to “ON”)

When the ignition switch is turned to the “ON” position, the display screen switches in the following order. 1- Screen when the ignition switch is “OFF” 2- System check screen 3- Screen

 ACD (Active centre differential system) control mode display screen

The ACD operation status is displayed. Refer to “ACD control mode switch”.

SEE MORE:

 Emergency towing

If towing service is not available in an emergency, your vehicle may be temporarily towed by a rope secured to the towing hook. If your vehicle is to be towed by another vehicle or if your vehicle tows another vehicle, pay careful attention to the following points: If your vehicle is to be tow

 Safety

The Insurance Institute for Highway Safety gave the Outlander Good overall scores, the highest rating possible, in its frontal-offset and side-impact crash tests. It received an Acceptable rating for its ability to prevent whiplash injuries in rear-end collisions. Standard safety features in

© 2010-2025 Copyright www.mioutlander.com