Mitsubishi Outlander: Lamps (headlamps, fog lamp, etc.) auto- cutout function
► If, while the lamp switch is in the “ ” position, the ignition switch is turned to the “LOCK” position or “ACC” position, or the key is removed from the ignition switch, the lamps automatically go out when the driver’s door is opened.
[When the engine was started using the key] If the key is removed and the driver’s door is opened, a buzzer sounds at a high pitch intermittently to remind the driver to turn off the lamps.
[When the engine was started using the keyless operation function] If the ignition switch is turned to the “LOCK” position and the driver’s door is opened, a buzzer sounds at a high pitch intermittently to remind the driver to turn off the lamps.
► If the ignition switch is turned to the “LOCK” position or “ACC” position,
or the key is removed from the ignition switch, while the lamp switch is in the
position, the lamps will remain on
for about 3 minutes while the driver’s door is shut and will then automatically
go out.
Note
► The lamp auto-cutout will not function when the lamp switch is in the
position.
► The lamp auto-cutout function can also be disabled.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
When you want to keep the lamps on:
1. Turn the lamp switch in the “OFF” position while the ignition switch is in
the “LOCK” or “ACC” position.
2. Turn on the lamps with the switch in the
position again, then the lamps will
remain on.
Note
► When the engine was started using the key, if the driver’s door is opened and the key is removed, the lamp monitor buzzer sounds at a high pitch intermittently.
The buzzer stops when the driver’s door is closed. (The warning is also displayed on the multi-information display.) The buzzer stops in the following manner.
• Turn the lamp switch to the “OFF” position.
• Close the driver’s door.
► When the engine was started using the keyless operation function, if the driver’s door is opened and the ignition switch is in the “LOCK” position, the lamp monitor buzzer sounds at a high pitch intermittently.
The buzzer stops when the driver’s door is closed. (The warning is also displayed on the multi-information display.) The buzzer stops in the following manner.
• Turn the lamp switch to the “OFF” position.
• Close the driver’s door.
READ NEXT:
Lamp monitor buzzer
[When the engine was started using the key] If the driver’s door is opened when
the key is in the “LOCK” or “ACC” position or removed from the ignition switch while
the lamps are on, a b
Dipper (High/Low beam change)
When the lamp switch is in the
position, the beam changes from high to low (or low to high) each time the lever
is pulled fully (1). While the highbeam is on, the high-beam indication lamp in
t
Headlamp flasher
The high-beams flash when the lever is pulled slightly (2), and will go off when
it is released.
When the high-beam is on, the high-beam indication lamp in the instrument cluster
will illuminate.
SEE MORE:
Voice recognition function
The Bluetooth® 2.0 interface is equipped with a voice recognition function.
Simply say voice commands and you can perform various operations and make or
receive hands-free calls.
With the Bluetooth® 2.0 interface, voice recognition is possible for English,
French, Spanish, Italian, German, D
Washing
Chemicals contained in the dirt and dust picked up from the road surface can
damage the paint coat and body of your vehicle if left in prolonged contact.
Frequent washing and waxing is the best way to protect your vehicle from this
damage. This will also be effective in protecting it from envir
