Mitsubishi Outlander: Lamp monitor buzzer
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Combination headlamps and dipper switch / Lamp monitor buzzer
[When the engine was started using the key] If the driver’s door is opened when the key is in the “LOCK” or “ACC” position or removed from the ignition switch while the lamps are on, a buzzer will sound to remind the driver to turn off the lamps.
[When the engine was started using the keyless operation function] If, while the lamps are illuminated, the ignition switch is set to the “LOCK” or “ACC” position, or the driver’s door is opened with the ignition switch set to the “LOCK” position, a buzzer will sound to remind the driver to turn off the lamps.
In both cases, the buzzer will automatically stop if the auto-cutoff function is activated, the lamp switch is turned off, or the door is closed.
READ NEXT:
Dipper (High/Low beam change)
When the lamp switch is in the
position, the beam changes from high to low (or low to high) each time the lever
is pulled fully (1). While the highbeam is on, the high-beam indication lamp in
t
Headlamp flasher
The high-beams flash when the lever is pulled slightly (2), and will go off when
it is released.
When the high-beam is on, the high-beam indication lamp in the instrument cluster
will illuminate.
Welcome light (for vehicles equipped with the keyless entry system or the keyless
operation system)
Except for vehicles for Russia, Kazakhstan and Ukraine, this function turns on
the position and tail lamps for about 30 seconds after the UNLOCK switch (A) on
the remote control transmitter is pre
SEE MORE:
To deactivate
The Auto Stop & Go (AS&G) system is automatically activated when the ignition
switch is turned to the “ON” position. You can deactivate the system by pressing
the “Auto Stop & Go (AS&G) OFF” switch.
When the Auto Stop & Go (AS&G) system is deactivated, the
disp
When turning from “LOCK” (PUSH OFF) to “ACC”
Push the ignition switch and turn it slowly.
A- Steering wheel locked
B- Steering wheel released
Note
► If the ignition switch does not turn from “LOCK” (PUSH OFF) to “ACC”, press
the ignition switch again, slightly move the steering wheel left and right, and
then turn the i
© 2010-2026 Copyright www.mioutlander.com
