Mitsubishi Outlander manuals

Mitsubishi Outlander: Leg area heating

Set the mode selection dial to the position shown in the illustration and set

Set the mode selection dial to the position shown in the illustration and set the air selection switch (A) to the outside position.

Adjust the temperature by turning the temperature control dial clockwise or anticlockwise.

Select the desired blower speed.

NOTE

When the maximum heating is needed, set the blower speed at 3rd position.

Combination of unheated air and heated air

READ NEXT:

 Combination of unheated air and heated air

Set the mode selection dial to the position shown in the illustration and set the air selection switch (A) to the outside position. The air will be directed to the leg area and the upper part of

 Demisting of the windscreen and door windows

CAUTION For safety, make sure you have a clear view through all windows. To remove frost or mist from the windscreen and door windows, use the mode selection dial (“” or “”). - To ke

 Introduction of outside air

To introduce air into the vehicle during hot weather, set the air selection switch (A) to the outside position and set the temperature control dial to the position shown in the illustration. Be

SEE MORE:

 Procedure for replacing the remote control switch battery

1. Remove the screw (A) from the remote control switch. 2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight blade (or minus) screwdriver into the notch in the remote control switch case and use it to open the case. NOTE • Be sure to perform the procedure

 Bottle holder

CAUTION • Do not drink beverages while driving. This is distracting and could cause an accident. • Drinks could be spilled by the vibration and jolts while driving. If the spilt drink is very hot, you could be burnt. There are bottle holders located on the front doors. NOTE • Tight

© 2010-2025 Copyright www.mioutlander.com