Mitsubishi Outlander: Manual reset mode
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Average speed display / Manual reset mode
► When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset.
► When the ignition switch is switched from “ACC” or “LOCK” to “ON”, the mode setting is automatically switched from manual to auto.
Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.
READ NEXT:
Auto reset mode
► When the average speed is being displayed, if you hold down the multi-information
meter switch, the average speed displayed at that time is reset.
► If the ignition switch is at “AC
Average fuel consumption display
This displays the average fuel consumption from the last reset to the present
time.
There are the following 2 mode settings.
For information on how to change the average fuel consumption display s
Manual reset mode
► When the average fuel consumption is being displayed, if you hold down the
multi-information meter switch, the average fuel consumption displayed at that time
is reset.
SEE MORE:
Rear window demister switch
The rear window demister switch can be operated when the engine is running.
Push the switch to turn on the rear window demister. It will be turned off automatically
in about 20 minutes. To turn off the demister within about 20 minutes, push the
switch again.
The indicator lamp (A) will illum
Bleeding the fuel system (diesel-powered vehicles only)
The fuel system should be bled to remove air as described below if the fuel supply
is exhausted during travel.
1. Undo the four clips on the air cleaner and push the cover (B) aside.
2. Press the pump (A) against the bracket (C) with your fingers until the pump
becomes stiff. Then pump sev
© 2010-2026 Copyright www.mioutlander.com
