Mitsubishi Outlander: Manual shift
Using the gearshift lever (A) or the shift paddles (B), shifting can be performed manually.
Shifting can be performed even while the accelerator pedal is depressed.
This allows the driver to enjoy sporty driving, such as quick cornering, by nimbly downshifting to reduce vehicle speed just before entering a curve.
Caution
► When manually shifting while the vehicle is being driven, select the correct
shift position to control the engine speed so that the tachometer indicator does
not enter the red zone.
► Sudden engine braking and rapid acceleration can cause the vehicle to skid. Shift
down according to road conditions and vehicle speed.
► If both the left and right shift paddles are operated at the same time, the transmission
may not change gears.
Note
► Only the forward gears 1 to 6 can be selected.
To reverse or park, place the gearshift lever in the “R” (REVERSE) or “P” (PARK)
position.
► During manual shifting, downshifting will be performed automatically when the
vehicle slows down and the transmission will downshift to 1st gear before the vehicle
stops.
► If the gearshift lever or shift paddles are operated repeatedly, the transmission
will also shift repeatedly.
► In order to ensure driving performance, upshifting may not occur depending on
the vehicle speed even if the gearshift lever or shift paddles are operated. In
addition, in order to prevent excessive engine speed, the buzzer sounds and downshifting
may not occur depending on the vehicle speed even if the gearshift lever or shift
paddles are operated.
► When driving in an aggressive manner involving high engine rpm, sudden acceleration
and/or deceleration, the Twin Clutch SST could take longer to shift due to higher
oil temperatures.
READ NEXT:
Shifting using the gearshift lever
Selecting manual shifting
While the vehicle is stopped or being driven, move the gearshift lever from the
“D” (DRIVE) position in the main shift gate towards the driver’s seat to select
man
Shifting using the shift paddles
Selecting manual shifting
While the vehicle is stopped or being driven with the gearshift lever in the
“D” (DRIVE) position, manual shifting can be selected by pulling one of the shift
paddle
Manual shift display
In manual shift, the currently selected gear is displayed on the multi-information
display.
SEE MORE:
Information screen (when the ignition switch is turned from “OFF” to “ON”)
When the ignition switch is turned to the “ON” position, the display screen switches
in the following order.
1- Screen when the ignition switch is “OFF”
2- System check screen
3- Screen when the ignition switch is “ON”
System check screen
When the ignition switch is turned to th
Cancelling the alarm
It is possible to halt the activation of an alarm using the following methods:
► Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will lock if all the doors and rear
hatch are closed, after which the system preparation mode will
