Mitsubishi Outlander: Multi centre display
When the ignition switch is in the ”ACC” position, the outside temperature and clock are displayed in the multi centre display. When the ignition switch is in the ”ON” position, the average fuel consumption is displayed besides outside temperature and digital clock.
If your vehicle is equipped with an automatic air conditioning system, set temperature, blower speed and air flow are displayed. (Refer to ”Automatic air conditioning” on page 6–36.)
A- Outside temperature / Set temperature*1
B- Blower speed*1
C- Air flow*1
D- Average fuel consumption*2
E- Digital clock
F- DISP button (For vehicles
with a MITSUBISHI genuine audio)
G- Display brightness / display unit selection
button
*1: Option
*2: Average fuel consumption:
For vehicles without MITSUBISHI genuine audio,
only average fuel consumption is displayed.
For vehicles with MITSUBISHI genuine
audio, driving range and average speed can be displayed besides average fuel consumption
by pushing the DISP button in the audio unit.
NOTE
(1) The display unit (ex. km or mile) and brightness can be changed as desired.
(Refer to ”Display brightness adjustment/Display unit selection” on page 4–31.)
When the system cannot provide a definite value for average fuel consumption/driving
range/average speed, it is displayed as ”– – –”.
(2) The figure of the display
varies according to the conditions under which a vehicle is travelling (road conditions,
the manner in which the vehicle is being driven, etc.). Observe display for reference
because the figure of the display may differ from the actual figure.
Outside temperature
This value shows the outside temperature of the vehicle.
If the outside temperature drops below about 3 C, the alarm sounds and the outside temperature figure flashes for about 5 seconds.
NOTE
(1) The outside temperature can be displayed from -40 C to 70 C.
(2) The
outside temperature displayed may differ from the actual temperature on account
of surrounding conditions, driving conditions, etc.
(3) If the temperature outside
the vehicle is below -40 C or over 70 C, an error message will be displayed (LO
C, HI C).
READ NEXT:
Digital clock
Following modes are available for clock adjustment: MITSUBISHI genuine audio:
“Auto mode” and “Manual mode”
Non genuine audio: “Manual mode” only
Selection of “Auto mode” or
Auto mode
(MITSUBISHI genuine audio only)
The automatic adjustment mode can set the local time automatically by using the
signal from the local RDS stations. In this mode, “CT” (A) (Clock Time: sent with
Manual mode
The manual adjustment mode is also available in case the “Auto mode” shows the
incorrect time when the adjacent local RDS stations are located in a different time
zone.
For manual time adjust
SEE MORE:
Air purifier
An air filter has been incorporated into this air conditioning so that pollen
and dust are cleaned from the air.
Replace the air filter periodically as its ability to clean the air will be reduced
as it collects pollen and dirt. For the maintenance interval, refer to the “SERVICE
BOOKLET”
Confident Braking Performance
The all-new 2008 Lancer GTS not only tames curves, but does so with the
confident stopping power of the same brakes as the larger, heavier Outlander SUV
-- 11.6-in. (294 mm) vented discs in front and 11.9-in. (302 mm) solid discs in
rear. The Lancer DE and ES models employ 10.9-in. (276 mm) ve
