Mitsubishi Outlander manuals

Mitsubishi Outlander: Operating the system in manual air mode

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / For pleasant driving / Automatic air conditioning / Operating the system in manual air mode

Blower speed and ventilator mode may be controlled manually by setting the blower speed selection dial and the mode selection dial to the desired positions.

To return to automatic operation, set the dials to the “AUTO” position.

Demisting of the windscreen and door windows

► For safety, make sure you have a clear view through all the windows. Caution

► For safety, make sure you have a clear view through all the windows.

To remove frost or mist from the windscreen and door windows, use the mode selection dial (). or For ordinary demisting).

For ordinary demisting

Use this setting to keep the windscreen and door windows clear of mist, and to keep the leg area heated.

1. Set the air selection switch (A) to the outside position.

1. Set the air selection switch (A) to the outside position.
2. Set the mode selection dial to the 3. Select your desired blower speed by turning the blower speed selection dial. position.
3. Select your desired blower speed by turning the blower speed selection dial.
4. Select your desired temperature by turning the temperature control dial.
5. Push the air conditioning switch (B).

For quick demisting

1. Set the mode selection dial to the

1. Set the mode selection dial to the 2. Set the blower to the maximum speed. position.
2. Set the blower to the maximum speed.
3. Set the temperature to the highest position.

► While the mode selection dial is set to the Note

► While the mode selection dial is set to the operate automatically and the outside air position will also be selected automatically. position, the air conditioning will operate automatically and the outside air position will also be selected automatically.
► To demist effectively, direct the air flow from the side ventilators towards the door windows.
► Do not set the temperature control dial to the max. cool position. Cool air will blow against the window glasses and prevent demisting.
► For vehicles with the Auto Stop & Go (AS&G) system, if the mode selection dial is set to the demister position shown in the illustration, the Auto Stop & Go (AS&G) system will not operate and the engine will not stop automatically even if the vehicle is stopped.
This is to ensure that good visibility is maintained.

READ NEXT:

 Important operation tips for the air conditioning

► Park the vehicle in the shade. Parking in the hot sun will make the vehicle inside extremely hot, and it will require more time to cool the interior. If it is necessary to park in the sun,

 Air purifier

An air filter has been incorporated into this air conditioning so that dirt and dust are cleaned from the air. Replace the air filter periodically as its ability to clean the air will be reduced

 LW/MW/FM digital tuning radio with CD player

The audio system can only be used when the ignition switch is in the “ON” or “ACC” position. Note ► When listening to the audio system while the engine is not running, be sure to

SEE MORE:

 Average speed

For vehicles with MITSUBISHI genuine audio, average speed can be displayed. This value shows the average speed (in km/h or mph) since the display was reset. If you reset the display at the time when you want to start the measurements, average speed from that point of time can be displayed.

 Cargo loads

Cargo loads precautions CAUTION: ● Do not load cargo or luggage higher than the top of the seatback. Be sure that your cargo or luggage cannot move once your vehicle is moving. Having the rear view blocked, and your cargo being thrown inside the cabin if you suddenly have to brake can

© 2010-2025 Copyright www.mioutlander.com