Mitsubishi Outlander: Operation of the Dead Lock System
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Locking and unlocking / Keyless operation system / To operate using the keyless operation function / Operation of the Dead Lock System
With a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the driver’s or front passenger’s door lock/unlock switch, or the rear hatch LOCK switch. (Refer to “Dead Lock System”.)
READ NEXT:
Electronic immobilizer (Anti-theft starting system)
The electronic immobilizer has been designed to significantly reduce the possibility
of vehicle theft.
The purpose of the system is to immobilize the vehicle if an invalid start is
attempted. A v
Ignition switch
In order to prevent theft, the engine will not start unless a preregistered keyless
operation key is used.
(Engine immobilizer function)
LOCK (PUSH OFF)
The position in which the steering wheel
When turning from “LOCK” (PUSH OFF) to “ACC”
Push the ignition switch and turn it slowly.
A- Steering wheel locked
B- Steering wheel released
Note
► If the ignition switch does not turn from “LOCK” (PUSH OFF) to “ACC”, press
SEE MORE:
To adjust seat height (driver’s seat only)
Manual type
To adjust the seat height, operate the lever repeatedly to adjust.
1- Raise
2- Lower
Power type
To adjust the seat height, operate the switch as indicated by arrows.
NOTE
• To prevent the battery from discharging, use the power seat while the engine
is on.
1- To move the
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “LOCK”, wait a few seconds, and then try again.
Trying repeatedly with the starter motor still turning will damag
© 2010-2025 Copyright www.mioutlander.com
