Mitsubishi Outlander: Retracting and extending the mirrors using the mirror retractor switch
With the ignition switch in the “ON” or “ACC” position, push the mirror retractor switch to retract the mirrors. Push it again to extend the mirrors to their original positions.
After placing the ignition switch in the “LOCK” position, it is possible to retract and extend the mirrors using the mirror retractor switch for about 30 seconds.
Caution
► It is possible to retract and extend the mirrors by hand. After retracting a mirror using the mirror retractor switch, however, you should extend it by using the switch again, not by hand. If you extended the mirror by hand after retracting it using the switch, it would not properly lock in position. As a result, it could move because of the wind or vibration while you are driving, taking away your rearward visibility.
Note
► Be careful not to get your hands trapped while a mirror is moving.
► If you move a mirror by hand or it moves after hitting a person or object, you
may not be able to return it to its original position using the mirror retractor
switch. If this happens, push the mirror retractor switch to place the mirror in
its retracted position and then push the switch again to return the mirror to its
original position.
► When freezing has occurred and mirrors fail to operate as intended, please refrain
from repeated pushing of the retractor switch as this action can result in burn-out
of the mirror motor circuits.
READ NEXT:
Retracting and extending the mirrors without using the mirror retractor switch
[Vehicles with keyless entry system] The mirrors automatically retract or extend
when the doors are locked or unlocked using the remote control switches of the keyless
entry system. Refer to “Ke
Heated mirror
To demist or defrost the outside rear-view mirrors, press the rear window demister
switch.
The indication lamp (A) will illuminate while the demister is on.
The heater will be turned off automatic
Ignition switch
[For vehicles equipped with keyless operation system]
For information on operations for vehicles equipped with the keyless operation
system, refer to “Keyless operation system: Ignition switch”
SEE MORE:
Headlamp washer switch
The headlamp washer can be operated when the ignition switch is in the “ON” or
“ACC” position and the headlamps are on.
Push the button once and the washer fluid will be sprayed on to the headlamps.
Note
► If the ignition switch is in the “ON” or “ACC” position and the
Fuse block
To prevent damage to the electric system due to short-circuiting or overloading,
each individual circuit is provided with a fuse. There are fuse boxes in the passenger
compartment and in the engine compartment.
The fuse box in the passenger compartment is located in front of the driver’s
