Mitsubishi Outlander: Starting the engine (Petrol-powered vehicles)

This vehicle is equipped with an electronically controlled fuel injection system
which is automatically controlled. When starting the engine, do not depress the
accelerator pedal.
READ NEXT:
The starting procedure is as follows :
1. Insert the ignition key and fasten the seat belt. 2. Apply the parking brake.
3. Depress and hold the brake pedal. 4. Place the gearshift lever (manual tra
If the engine has become flooded during starting, first operate the starter for
5 to 6 seconds while fully depressing the accelerator pedal, then start the engine
without depressing the accelerato
If the engine won’t start, depress the accelerator pedal about halfway while
cranking the engine. Once the engine starts, release the accelerator pedal.
CAUTION
When starting the engine, make su
SEE MORE:
To check the fluid level
The AWC control fluid reservoir is in the luggage compartment.
Note
► Check the fluid level in the reservoir 90 minutes or more after turning the
ignition switch to the “LOCK” position.
1. Remove the lid of the cargo floor box (A) on the right side.
2. Re
If a hand or head is trapped in the closing window, it will lower automatically.
Nonetheless, make sure that nobody puts their head or hand out of the window
when closing the driver’s door window.
The lowered window will become operational after a few seconds.
Warning
► If the safety
© 2010-2026 Copyright www.mioutlander.com
