Mitsubishi Outlander: To reduce the glare
Type 1
The lever (A) at the bottom of the mirror can be used to adjust the mirror to reduce the glare from the headlamps of vehicles behind you during night driving.
1- Normal
2- Anti-glare
Type 2
When the headlamps of the vehicles behind you are very bright, the reflection factor of the rear-view mirror is automatically changed to reduce the glare.
When the ignition switch is turned to the “ON” position, the green indicator (1) illuminates and the reflection factor of the mirror is automatically changed.
Note
► Do not hang any items on, or spray glass cleaner on the sensors (2) on the
front and back side, as reduced sensitivity could result.
► If you want to stop automatic mode, press the switch (3) and the indicator will
go off.
To return to automatic mode, press the switch again or turn the ignition switch
to the “ON” position after turning to “LOCK” or “ACC” position.
READ NEXT:
To adjust the mirror position
The outside rear-view mirrors can be operated when the ignition switch is in
the “ON” or “ACC” position.
Warning
► Do not attempt to adjust the rear-view mirrors while driving. This
Retracting and extending the outside mirrors
The outside mirror can be folded in towards the side window to prevent damage
when parking in narrow areas.
Caution
► Do not drive the vehicle with the mirror folded in.
The lack of rearwa
SEE MORE:
Safe driving techniques
Driving safety and protection against injury cannot be fully ensured. However,
we recommend that you pay extra attention to the following:
(1) Before starting the vehicle, make sure that you and your passengers have
fastened your seat belts. (2) Never leave your vehicle unattended with the key
To remove
1. Wrap the tip of the bar with a cloth, insert it deeply into the notch provided
in the wheel cover, and use it to lever up the cover a little.
2. With the cover raised a little, pry it off completely using the jack bar.
Insert the jack bar under the cover, and move it around the circumferen
