Mitsubishi Outlander: To remove the key
For vehicles equipped with a M/T, when removing the key, push the key in at the “ACC” position and keep it depressed until it is turned to the “LOCK” position, and remove it.
For vehicles with CVT or Twin Clutch SST, when removing the key, first set the selector lever (CVT) or gearshift lever (Twin Clutch SST) to the “P” (PARK) position, and then turn the key to the “LOCK” position and remove it.
Caution
► Do not remove the ignition key from the ignition switch while driving. The
steering wheel will be locked, causing loss of control.
► If the engine is stopped while driving, the brake servomechanism will cease to
function and braking efficiency will deteriorate.
Also, the power steering system will not function and it will require greater manual
effort to operate the steering.
► Do not leave the key in the “ON” position for a long time when the engine is not
running, doing so will cause the battery to be discharged.
► Do not turn the key to the “START” position when the engine is running, doing
so could damage the starter motor.
READ NEXT:
Steering wheel lock
[For vehicles equipped with keyless operation system]
For information on operations for vehicles equipped with the keyless operation
system, refer to “Keyless operation system: Steering wheel loc
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “LOCK”, wait a
SEE MORE:
Refill capacities
1: Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrate
and non-borate coolant with long life hybrid organic acid technology
2: If so equipped
1: Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrate
and non-borate coolant with long
System preparation mode (approx. 20 seconds)
(The buzzer sounds intermittently and the security indicator (A) blinks.)
The system preparation time extends from the point at which all of the doors
and rear hatch are locked by pressing the LOCK switch on the remote control switch
or the keyless operation function to the point at which the
