Mitsubishi Outlander: System preparation mode (approx. 20 seconds)
(The buzzer sounds intermittently and the security indicator (A) blinks.)

The system preparation time extends from the point at which all of the doors
and rear hatch are locked by pressing the LOCK switch on the remote control switch
or the keyless operation function to the point at which the system armed mode goes
into effect.
During this time, it is possible to temporarily open a door or the rear hatch
without using the keyless entry system or the keyless operation function and without
causing the alarm to sound (for example, when you forget something inside the vehicle
or realize that a window is open).
READ NEXT:
(The buzzer stops and the security indicator continues to blink with indicator’s
reduced lit-up duration time.) Once the system preparation mode has ended, the system
armed mode starts.
If an u
The turn-signal lamps blink and the siren sounds for approximately 30 seconds.
Refer to “Alarm activation”.
Note
► The alarm will resume if unlawful actions are taken again, even if the
It is possible to cancel the system activation during the system preparation
mode or the system armed mode.
In addition, it is possible to cancel the alarm once it has been activated.
Refer to “
SEE MORE:
The seat belt anchor height can be adjusted.
Raise or lower the seat belt anchor (A) while pressing the lock knob (B).
WARNING
• When adjusting the seat belt anchor, set it at a position that is sufficiently
high so that the belt will make full contact with your shoulder but will not touch
To change the position and amount of air flowing from the ventilators, turn the
mode selection dial.
(Refer to “Mode selection dial”.) These symbols are used in the
next several illustrations to demonstrate the quantity of air coming from the ventilators.
: Small amount of air from the ven
© 2010-2026 Copyright www.mioutlander.com
