Mitsubishi Outlander: To resume set speed
Mitsubishi Carisma / Mitsubishi Carisma Owner's Manual / Starting and driving / Auto–speed (cruise) control* / To resume set speed
If the vehicle speed remains 40 km/h or higher when the auto–speed control is deactivated by operating the auto–speed control lever or by any one of the (2) to (7) conditions noted above, the previously set speed can be automatically resumed by pulling up the auto–speed control lever.
READ NEXT:
UKW/MW/LW electronic tuning radio with tape player*
The audio system can be used when the ignition switch is in the “ON” or “ACC”
position.
A– Display window B– Audio system
NOTE
(1) The MITSUBISHI Genuine CD player or CD autochanger
To listen to the radio
1- PWR (On-off) switch 2- VOL (Volume control) knob 3- U/M/L (UKW/MW/LW selection)
button 4- Audio adjust button 5- AUDIO button 6- TUNE/SEEK (Down-step/Down-seek)
button 7- TUNE/SEEK (Up-step/U
SEE MORE:
To resume the set speed
If the set speed driving is deactivated by the condition described in “To deactivate”, you can resume the previously set speed by pressing the “ACC RES”
switch (C) while driving at a speed of about 40 km/h (25 mph) or higher.
Under either of the following conditions, however, using the
Radio data system (RDS)
1- PWR (On-Off) switch
2- AM/FM (FM/MW/LW selection) button
3- Memory select buttons
4- TP (Traffic program) button
5- PTY (Program type) button
6- TUNE switch
7- SEEK (Up-seek) button
8- SEEK (Down-seek) button
9- CT (Clock time) indicator
10- RDS (Radio data system) indicator
11- TP
© 2010-2025 Copyright www.mioutlander.com
