Mitsubishi Outlander manuals

Mitsubishi Outlander: To store the flat tyre or spare wheel

1. Lift up the board.
2. To store the flat tyre or spare wheel, fit the installation clamp (A) by turning it clockwise.

Note

► On vehicles equipped with a compact spare wheel, the clamp cannot be used for Note

► On vehicles equipped with a compact spare wheel, the clamp cannot be used for a normal size tyre.

3. Have your damaged tyre repaired as soon as possible.

To store the tools and jack

Reverse the removing procedure when storing the jack, bar and wheel nut wrench. Refer to “Tools and jack”.

READ NEXT:

 Wheel covers

 To remove

1. Wrap the tip of the bar with a cloth, insert it deeply into the notch provided in the wheel cover, and use it to lever up the cover a little. 2. With the cover raised a little, pry it off comp

 To install

1. Make sure the tabs (A) of the back of the wheel cover are not broken and correctly fitted on the rings (B). If in doubt, do not install the wheel cover and consult your MITSUBISHI MOTORS Author

SEE MORE:

 Operating the system in automatic mode

In normal conditions, use the system in the AUTO mode and follow these procedures: 1. Set the blower speed selection dial to the “AUTO” position. 2. Set the temperature control dial to the desired temperature. 3. Set the mode selection dial to the “AUTO” position. The outlet position

 ACD control mode display

Example: “TARMAC” mode is selected. The currently selected control mode is displayed on the multi-information display. In addition, when the control mode is changed, the selected mode appears on the interrupt display screen of the information screen in the multi-information display. The c

© 2010-2025 Copyright www.mioutlander.com