Cleaning

If the windshield does not become clear after operating the windshield washer, or if the wiper blades chatter, skip, or leave streaks while moving, wax, dirt, road film, or other contamination may be present on the blades or windshield.

Clean the outside surface of the windshield with windshield washer solution or a mild detergent. The glass is considered clean when water spreads evenly over the surface rather than forming beads when rinsed with clear water.

Clean each wiper blade by wiping the rubber edge carefully with a cloth soaked in washer solution or a mild detergent.

After cleaning, rinse the blades thoroughly with clean water. If visibility through the windshield remains poor after the blades and glass have been cleaned and the wipers are used again, replace the wiper blades.

CAUTION

  • Worn, cracked, or damaged windshield wiper blades can scratch the windshield and reduce driver visibility, particularly in rain or other adverse weather.

Replacing

Mitsubishi Outlander windshield wiper blade removal and installation procedure

Replace the windshield wiper blades when they become worn, damaged, or no longer clean the glass effectively.

1. Carefully lift the wiper arm away from the windshield.

2. Pull up release tab A, rotate the wiper blade to the angle shown, and then push the blade downward in line with wiper arm 1 to remove it.

3. Insert the new wiper blade onto the wiper arm and push it into position until it clicks securely into place.

4. Push release tab A down to lock the wiper blade, then carefully lower the wiper arm back onto the windshield.

CAUTION

  • After replacing a wiper blade, return the wiper arm to its normal resting position. If the arm is left raised or incorrectly positioned, it may be damaged when the hood is opened.
  • Make sure the wiper blade rests correctly against the windshield glass. Incorrect positioning may allow wind pressure to place excessive force on the wiper arm and cause damage.

Rear window wiper blade

If inspection or replacement of the rear window wiper blade is required, it is recommended that you contact an authorized Mitsubishi Motors dealer for service.

    READ NEXT:

     Brakes

    If the braking system does not operate normally or braking performance appears reduced, have the Mitsubishi Outlander inspected as soon as possible. It is recommended that you visit an authorized Mits

     Fuses

    Engine compartment WARNING Never install a fuse with an amperage rating higher or lower than the value specified on the fuse box cover. Using an incorrectly rated fuse can damage the electric

     Transmitter battery replacement

    CAUTION Keep the battery and all removed transmitter components out of the reach of children to prevent accidental swallowing. Improper battery disposal can harm the environment. Always follow a

    SEE MORE:

     Three-point type seat belt with retractor

    The three-point seat belt used in the Mitsubishi Outlander combines a lap belt and shoulder belt with a retractor that allows normal body movement while helping restrain the occupant during sudden braking or certain impacts. Correct seat position and proper belt routing are essential for the system

     S-AWC (Super-All Wheel Control)

    S-AWC is an integrated vehicle dynamics control system designed to enhance driving performance, cornering capability, and overall vehicle stability across a wide range of road and driving conditions. In the Mitsubishi Outlander, S-AWC coordinates the operation of the electronically controlled AWC, A