Mitsubishi Outlander: Changing the fuel consumption display unit
The display unit for fuel consumption can be switched.
The distance, speed, and amount units are also switched to match the selected fuel consumption unit.
1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select “AVG UNIT (fuel consumption display setting)”.
3. Press and hold the multi-information meter switch for about 2 seconds or more to display “AVG UNIT” (fuel consumption display unit setting).
4. Lightly press the multi-information meter switch to switch in sequence from km/L → L/100 km → mpg (US) → mpg (UK) → RETURN → km/L.
5. Press and hold the multi-information meter switch for about 2 seconds or more to change the setting to the selected unit.
Note
► The display units for the driving range, the average fuel consumption, the
average speed and the momentary fuel consumption are switched, but the units for
the indicating needle (speedometer), the odometer and the tripmeter will remain
unchanged.
► The memory of the unit setting is erased if the battery is disconnected, and it
returns automatically to L/100 km.
The distance and speed units are also switched in the following combinations to match the selected fuel consumption unit.
READ NEXT:
Changing the temperature unit
The display unit for temperature can be switched.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen. Refer t
Changing the display language
The language of the multi-information display can be switched.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu sc
Changing the language cooperative control
The language used in MITSUBISHI Multi-Communication System (MMCS) (if so equipped)
or the Bluetooth® 2.0 interface (if so equipped) can be changed automatically to
the same language as that shown
SEE MORE:
Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
: Front of the vehicle
3. Turn the bulb (C) antic
Interrupt display screen (when the ignition switch or the operation mode is
ON)
Warning display
When there is information to be announced, such as a system fault, a sound is
emitted and the information screen switches to the warning display screen.
Refer to the warning list and take the necessary measures.
Refer to “Warning display list (when the ignition switch or the o
