Mitsubishi Outlander manuals

Mitsubishi Outlander: Diagnostic Trouble Code Procedures

Mitsubishi Outlander 2007-2013 Service Manual / Brakes and Steering / Active Stability Control System (ASC) / Diagnostic Trouble Code Procedures

READ NEXT:

 DTC C100A, C1015, C1020, C102B, C1011, C101C, C1027, C1032, C1014, C101F, C102A, C1035

DTC C100A: Abnormality in FL wheel speed sensor circuit Wheel Speed Sensor Circuit CAUTION If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to

 DTC C1035, C1041, C1042, C1043, C1044, C1046, C1047, C1048, C1049, C104B, C104F, C1053, C1057, C105F, C1063, C1067, C105B, C1200, C1204, C1208, C120C

DTC C1035 Mutual monitoring of RR wheel speed sensor CAUTION If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer t

 DTC C2104, C1073, C2116, C121D, C121E, C1000

DTC C2104: Faulty valve power supply circuit Solenoid Valve and Motor Power Supply Circuit CAUTION If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. P

SEE MORE:

 Outside rear-view mirrors

To adjust the mirror position The outside rear-view mirrors can be operated when the ignition switch is in the “ON” or “ACC” position. WARNING: ● Do not attempt to adjust the rear-view mirrors while driving. This can be dangerous. Always adjust the mirrors before driving. ●

 DTC P0703, P0705, P0711, P0712, P0713, P0715, P0720, P0725, P0740, P0741, P0745

DTC P0703: Malfunction of Stoplight Switch Stoplight switch system circuit DIAGNOSTIC FUNCTION TCM detects malfunction using the stoplight switch signal sent from the ETACS-ECU. DESCRIPTIONS OF MONITOR METHODS Drive the vehicle at 30 km/h (19 mph) or more for 10 seconds, and then turn the igni

© 2010-2026 Copyright www.mioutlander.com