Mitsubishi Outlander: Engine coolant temperature display
Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Engine coolant temperature display
This indicates the engine coolant temperature.
If the coolant becomes hot, 
will
blink.
Pay careful attention to the engine coolant temperature display while you are driving.
Caution
► If the engine is overheating,
will blink. In this case, the bar
graph is on the red zone.
lmmediately park the vehicle in a safe place and take the required measures. Refer
to “Engine overheating”.
READ NEXT:
Driving range display
This displays the approximate driving range (how many more kilometres or miles
you can drive).
When the driving range falls below approximately 50 km (30 miles), “---” is displayed.
Refuel as
Average speed display
This displays the average speed from the last reset to the present time.
There are the following 2 mode settings.
For the method for changing the average speed display setting, refer to “Changing
Manual reset mode
► When the average speed is being displayed, if you hold down the multi-information
meter switch, the average speed displayed at that time is reset.
► When the ignition switch is switch
SEE MORE:
Link System
The Link System takes overall control of the devices connected via the USB input
terminal or the Bluetooth® 2.0 interface allowing the connected devices to be operated
by using the switches in the vehicle or voice commands.
See the following section for details on how to operate.
Refer to “
AWC control fluid
To check the fluid level
The AWC control fluid reservoir is in the luggage compartment.
Note
► Check the fluid level in the reservoir 90 minutes or more after turning the
ignition switch to the “LOCK” position.
1. Remove the lid of the cargo floor box (A) on the right side.
2. Re
© 2010-2026 Copyright www.mioutlander.com
