Mitsubishi Outlander: How to connect a USB memory device
1. Park your vehicle in a safe place and turn the ignition switch to the “LOCK”
position.
2. Open the USB input terminal cover (A) in the glove box.
3. Connect a commercially available USB connector cable (C) to the USB memory device (B).
4. Connect the connector cable (C) to the USB input terminal (D).
Caution
► Keep the lid of the glove box closed while driving the vehicle. A lid or the contents of the glove box could otherwise cause injuries.
Note
► Do not connect the USB memory device to the USB input terminal directly.
The USB memory device may be damaged.
► When closing the glove box, be careful not to trap the connector cable.
5. To remove the connector cable, turn the ignition switch to the “LOCK” position first and perform the installation steps in reverse.
READ NEXT:
How to connect an iPod
1. Park your vehicle in a safe place and turn the ignition switch to the “LOCK”
position.
2. Open the USB input terminal cover (A) in the glove box.
3. Connect the Dock connector (C) to the
Types of connectable devices and supported file specifications
Device types
Devices of the following types can be connected.
: “iPod touch,” “iPod classic,” “iPod” and “iPod nano” are registered trademarks
of Apple Inc. in the United States
Sun visors
1- To eliminate front glare
2- To eliminate side glare
SEE MORE:
Rear window wiper and washer switch (Hatchback)
The rear window wiper and washer switch can be operated with the ignition switch
at the “ON” or “ACC” position.
Rear window wiper
Turn the knob, and the rear window wiper will operate.
Type 1
- To operate the wiper
- Off
Type 2
- To operate the wiper
- Intermittent operatio
Stop and tail lamps and rear turn-signal lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a
cloth or other object at the edge of the cover and pry gently to remove the cover.
2. Remove the socket and bulb assemblies by turning them anticlockwise.
A- Rear turn-signal lamp
B- Stop and tail lamp
3. Remove
