Mitsubishi Outlander: LW/MW/FM digital tuning radio with CD changer
The audio system can only be used when the ignition switch is in the “ON” or “ACC” position.
Note
► When listening to the audio system while the engine is not running, be sure
to turn the ignition switch to the “ACC” position.
If the ignition switch is left in the “ACC” position, the accessory power will automatically
turn off after a certain period of time and you will no longer be able to use the
audio system. The accessory power comes on again if the ignition switch is turned
from the “ACC” position. Refer to “ACC power autocutout function”.
► If a cellular phone is used inside the vehicle, it may create noise from the audio
equipment.
This does not mean that anything is wrong with your audio equipment. In such a case,
use the cellular phone at a place as far away as possible from the audio equipment.
► If foreign objects or water get into the audio equipment, or if smoke or a strange
odour comes from it, immediately turn off the audio system. We recommend you to
have it checked. Never try to repair it by yourself.
Avoid continuous usage without inspection by a qualified person.
► The audio amplifier (if so equipped) is located under the front left seat. Do
not subject the amplifier to a strong impact. It could damage the amplifier or malfunctioning
could result.
- Volume and tone control panel
- To adjust the volume
- To adjust the tone
- SCV (Speed Compensated Volume) function
- Radio control panel and display
- To listen to the radio
- Radio data system (RDS)
- CD control panel and display
- To listen to a CD
READ NEXT:
Volume and tone control panel
1- PWR (On-Off) switch
2- VOL (Volume control) knob
3- Display
4- SOUND (Sound control) switch
To adjust the volume
VOL (Volume control)
Turn the VOL knob (2) clockwise to increase the volume; anticlockwise to decrease
the volume.
To adjust the tone
Press the SOUND switch (4) to select: SUB PUNCH → TYPE → FIELD → BASS → MID →
TREBLE → FADER → BALANCE → audio control mode OFF.
Note
► The S
SEE MORE:
Rear room lamp
The room lamp can be turned on by sliding the room lamp switch.
1 (ON) - The room lamp goes on.
2 ( ) - The lamp illuminates when a door or the rear hatch is opened. It goes
off about 15 seconds after the door or rear hatch is closed.
However, the lamp goes off immediately in the following ca
Waiting
For short waiting periods, such as at traffic signals, the gearshift lever can
be left in position and the vehicle held stationary with the service brake.
For longer waiting periods with the engine running, place the gearshift lever
in the “N” (NEUTRAL) position and apply the parking brake,
