Mitsubishi Outlander: Air selection switch
To change the air selection, simply press the air selection switch.
A sound will be made every time you push the switch.
► Outside air: Indication lamp (A) is OFF Outside air is introduced into the
passenger compartment.
► Recirculated air: Indication lamp (A) is ON Air is recirculated inside the passenger
compartment.
Caution
► Normally, use the outside position to keep the windscreen and side windows
clear and quickly remove fog or frost from the windscreen.
If the outside air is dusty or otherwise contaminated use the recirculation position.
Switch to the outside position periodically to increase ventilation so that the
windows do not become fogged up.
► Use of the recirculation position for extended time may cause the windows to fog
up.
Note
► When the heater operates with the selection switch in the outside position,
the system automatically determines whether to continue using outside air or to
perform recirculation.
If the outside air temperature is high, the system selects recirculation and causes
the indication lamp (A) in the switch to illuminate.
Press the selection switch to return to outside air introduction.
READ NEXT:
Customizing the air selection (Changing function settings)
Functions can be changed as desired, as stated below.
► Enable automatic air control:
When the heater operates, the air selection switch will be automatically controlled.
► Disable auto
Operating the heater system
Heating
Set the mode selection dial to the
position and set the air selection
switch (A) to the outside position.
Turn the temperature control dial clockwise or anticlockwise to the desired temp
Manual air conditioning
The air conditioning can only be used while the engine is running.
SEE MORE:
Washer fluid
Open the washer fluid reservoir cap and check the level of washer fluid with
the dipstick.
If the level is low, replenish the container with washer fluid.
NOTE:
● The washer fluid container serves the windscreen, rear window and headlamps.
During cold weather
To ensure proper operatio
To deactivate
The set speed driving can be deactivated as follows: ► Press the “ON OFF” switch
(A). (Cruise control will be turned off.)
► Press the “CANCEL” switch (D).
► Depress the brake pedal.
The set speed driving is deactivated automatically in any of the following ways.
&#
