Mitsubishi Outlander manuals

Mitsubishi Outlander: Heater

The heater can only be used while the engine is running.

READ NEXT:

 Control panel

A- Temperature control dial B- Air selection switch C- Blower speed selection dial D- Mode selection dial E- Rear window demister switch Note ► Button (F) is not available for use. The

 Blower speed selection dial

Select the blower speed by turning the blower speed selection dial clockwise or anticlockwise. The blower speed will gradually increase as the dial is turned to the right.

 Temperature control dial

Turn the temperature control dial clockwise or anticlockwise. Note ► While the engine coolant temperature is low, the temperature of the air from the heater will be cool/cold until the engi

SEE MORE:

 Tips for starting

► Do not operate the starter motor continuously longer than 10 seconds; doing so could run down the battery. If the engine does not start, turn the ignition switch back to “LOCK”, wait a few seconds, and then try again. Trying repeatedly with the starter motor still turning will damag

 Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)

Do not attempt to disassemble or repair headlamps, and do not attempt to replace their bulbs. Warning ► A high voltage is present in the power circuit and in the bulbs and bulb terminals. To avoid the risk of an electric shock, contact a MITSUBISHI MOTORS Authorized Service Point whe

© 2010-2025 Copyright www.mioutlander.com