Mitsubishi Outlander: Except for vehicles equipped with rain sensor
The windscreen wiper and washer can be operated with the ignition switch in the “ON” or “ACC” position.
If the blades are frozen to the windscreen, do not operate the wipers until the ice has melted and the blades are freed, otherwise the wiper motor may be damaged.
MIST- Misting function
The wipers will operate once.
OFF- Off
INT- Intermittent (Speed sensitive)
LO- Slow
HI- Fast
To adjust intermittent intervals
With the lever in the “INT” (speed-sensitive intermittent operation) position, the intermittent intervals can be adjusted by turning the knob (A).
1- Fast
2- Slow
Note
► The speed-sensitive-operation function of the windscreen wipers can be deactivated.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized
Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations
can be used to make the adjustment.
Refer to the separate owner’s manual for details.
Misting function
The misting function can be used when the ignition switch is in the “ON” or “ACC” position.
The wipers will operate once if the wiper lever is raised to the “MIST” position and released. This operation is useful when it is drizzling, etc. The wipers will continue to operate while the lever is held in the “MIST” position.
READ NEXT:
Vehicles with rain sensor
The windscreen wipers can be operated with the ignition switch in the “ON” or
“ACC” position.
If the blades are frozen to the windscreen, do not operate the wipers until the
ice has melte
Windscreen washer
The windscreen washer can be operated with the ignition switch in the “ON” or
“ACC” position.
The washer fluid will be sprayed onto the windscreen by pulling the lever towards
you.
When
Rear window wiper and washer
The rear window wiper and washer switch can be operated with the ignition switch
in the “ON” or “ACC” position.
INT- The wiper operates continuously for several seconds then operates inte
SEE MORE:
Engine oil level warning display
When the ignition switch is in the “ON” position, if it is suspected that the
engine oil level has increased excessively, the warning display is displayed on
the information screen in the multi-information display.
Caution
► If this warning is displayed while driving, stop the veh
Antenna
Roof antenna
To remove
Turn the pole (A) anticlockwise.
To install
Screw the pole (A) clockwise into the base (B) until it is securely retained.
NOTE:
● Be sure to remove the roof antenna in the following cases:
• When going into an automatic car wash.
• When placing a car cover
