Mitsubishi Outlander: Diagnostic Trouble Code Procedures
- DTC C100A, C1015, C1020, C102B, C1011, C101C, C1027, C1032, C1014,
C101F, C102A, C1035
- DTC C1041, C1042, C1043, C1044, C1046, C1047, C1048, C1049, C104B,
C104F, C1053, C1057, C105F, C1063, C1067, C105B
- DTC C2104, C1073, C2116, C1000, C2200, C2100, C2101, C1395, C2203,
C1608, U0001, U0100, U0141, U1415, U1417
READ NEXT:
DTC C100A: Abnormality in FL wheel speed sensor circuit
Wheel Speed Sensor Circuit
CAUTION
If there is any problem in the CAN bus lines, an incorrect
DTC may be set. Prior to this diagnosis, diagnos
DTC C1041: Abnormality in periodical signal for FL wheel speed sensor
CAUTION
If there is any problem in the CAN bus lines, an incorrect
DTC may be set. Prior to this diagnosis, diagnose
the CAN b
DTC C2104 Faulty valve power supply circuit
Power Supply Circuit
CAUTION
If there is any problem in the CAN bus lines, an incorrect
DTC may be set. Prior to this diagnosis, diagnose the CAN
bus line
SEE MORE:
Inspection Procedure 1: TCM cannot communication with scan tool.
TCM POWER SUPPLY CIRCUIT
SYMPTOMS
TCM cannot be turned ON.
PROBABLE CAUSES
Damaged wiring harness and connectors
Malfunction of TCM
DIAGNOSTIC PROCEDURE
STEP 1. Check the following connector:
A-18X CVT control relay connector
C
CAN BUS DIAGNOSTICS TABLE
CAUTION
A diagnostic trouble code may not also be set in
the CAN-B lines under the conditions below. If no
diagnostic trouble code has been set due to electrical
noise, confirm diagnostic item 26.
Open circuit at the CAN_H side of the CAN-B
bus lines
Open circuit at the
© 2010-2025 Copyright www.mioutlander.com
