Mitsubishi Outlander: Headlight
- General Information, Diagnosis
- Diagnostic Trouble Code Procedures
- Symptom Procedures
- On-vehicle Service
READ NEXT:
General Information, Diagnosis
General Information
As for headlight assembly, a type with halogen
bulbs for the high-beam and low-beam and a type
with a discharge bulb for both high-beam and
low-beam are established.
The hal
Diagnostic Trouble Code Procedures
DTC B16A2: Blown turn-signal light (LH) bulb
Turn-Signal Light Circuit (LH)
TROUBLE JUDGMENT
When the left bulb of turn-signal light is blown, the
ETACS-ECU sets DTC B16A2.
TECHNICAL DESCRIPTION (
Symptom Procedures
Inspection Procedure 1: None of headlights (low-beam) illuminates.
CAUTION
Whenever the ECU is replaced, ensure that the
power supply circuit, the ground circuit and the
communication circuit are norm
SEE MORE:
DTC B1B08, B1B09, B1B0A, B1B0B, B1B0C, B1B0D, B1B0E, B1B0F, B1B18, B1B19
DTC B1B08: Passenger's (Front) Air Bag Module (1st squib) System (Shorted
to Squib Circuit
Ground)
DTC B1B0C: Passenger's (Front) Air Bag Module (2nd squib) System (Shorted to
Squib Circuit
Ground)
Passenger's (Front) Air Bag Module (Squib) Circuit
CAUTION
If DTC B1B08 <1st squib> or B1B
Air purifier
An air filter has been incorporated into this air conditioning so that pollen
and dust are cleaned from the air.
Replace the air filter periodically as its ability to clean the air will be reduced
as it collects pollen and dirt. For the maintenance interval, refer to the “SERVICE
BOOKLET”
© 2010-2026 Copyright www.mioutlander.com
