Mitsubishi Outlander: Door
- General Information
- Symptom Procedures (Central Door Locking System)
- Input Signal Procedures (Central Door Locking System)
- Power Window Diagnosis
- Symptom Procedures (Power Window)
- Door Diagnosis
- On-vehicle Service
- Door Assembly, Door Glass and Regulator, Door Handle and Latch
READ NEXT:
General Information
CENTRAL DOOR LOCKING SYSTEM
The central door locking system operates the door
lock actuator to lock or unlock the doors and liftgate
using the door lock switch built into the front power
window (main
Symptom Procedures (Central Door Locking System)
INSPECTION PROCEDURE A-1: Central Door Locking System does not Work at
All.
CAUTION
Before replacing the ECU, ensure that the power supply circuit, the ground
circuit and the communication
circuit a
Input Signal Procedures (Central Door Locking System)
INSPECTION PROCEDURE B-1: The Liftgate Lock Release Handle Signal is
not Received.
CAUTION
Before replacing the ECU, ensure that the power supply circuit, the ground
circuit and the communication
ci
SEE MORE:
Intake Manifold and Fuel System
REMOVAL AND INSTALLATION
Removal steps
Oil dipstick rod
O-ring
Injector protector rear
Bracket
Bracket
Fuel rail assembly
Injection support
O-ring
Injector
O-ring
Fuel rail
Intake manifold stay
Intake manifold stay B
Intake manifold stay C
Injector protector front
Intake manifold
DTC P0876, P0893, P0988, P1705, P1706, P1731, P1753, P1758, P1773,
P1796, U0001, U0100, U0121, U0141
DTC P0876: High Clutch Pressure Switch System
DESCRIPTIONS OF MONITOR METHODS
With the solenoid failure not detected and with
4th to 6th gear driving, the switch OFF status
continues for 2 seconds. (The detection is
achieved twice during 1 driving cycle*1, and it
continues for 2 driving cycles
© 2010-2025 Copyright www.mioutlander.com
